From: Lee (kinwei@xxxxxxxxxxxx)
Date: Mon Dec 24 2001 - 16:04:49 GMT-3
Hi all, i'm doing the configuration exercise for Q.4 on chapter 14(route
map). In my senario, i have 3 routers. R1(OSPF)---- FR----(EIGRP)R2. FR is
the one doing redistribution. As you can see below, all EIGRP routes are
internal except 10.202.100.0.
FR#s
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate
default
U - per-user static route, o - ODR
Gateway of last resort is not set
10.0.0.0/24 is subnetted, 6 subnets
O 10.102.100.0 [110/65] via 192.168.1.2, 00:13:38, Serial0
O 10.100.100.0 [110/65] via 192.168.1.2, 00:13:38, Serial0
O 10.101.100.0 [110/65] via 192.168.1.2, 00:13:38, Serial0
D EX 10.202.100.0 [170/2195456] via 192.168.100.2, 00:20:33, Serial1
D 10.200.100.0 [90/2195456] via 192.168.100.2, 00:20:33, Serial1
D 10.201.100.0 [90/2195456] via 192.168.100.2, 00:20:33, Serial1
D 192.168.102.0/24 [90/2195456] via 192.168.100.2, 00:20:33, Serial1
C 192.168.1.0/24 is directly connected, Serial0
O 192.168.2.0/24 [110/65] via 192.168.1.2, 00:13:38, Serial0
C 192.168.100.0/24 is directly connected, Serial1
O 192.168.3.0/24 [110/65] via 192.168.1.2, 00:13:39, Serial0
D 192.168.101.0/24 [90/2195456] via 192.168.100.2, 00:20:34, Serial1
With the solution in appendix, after redistributed, i thought only
10.202.100.0 will becomes O-E2. After i checked the routing table on R1, all
redistributed EIGRP routes have been changed as O-E2 except 10.201.100.0. By
right, this route '10.201.100.0' should not be redistribute with the
route-map control in FR. You can see the routing table on R1 below:
r1#sh ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter
area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
10.0.0.0/24 is subnetted, 6 subnets
C 10.102.100.0 is directly connected, FastEthernet0/0
C 10.100.100.0 is directly connected, FastEthernet0/0
C 10.101.100.0 is directly connected, FastEthernet0/0
O E2 10.202.100.0 [110/20] via 192.168.1.1, 00:09:54, Serial0/0
O E2 10.200.100.0 [110/20] via 192.168.1.1, 00:09:56, Serial0/0
O E1 10.201.100.0 [110/74] via 192.168.1.1, 00:09:56, Serial0/0
O E2 192.168.102.0/24 [110/20] via 192.168.1.1, 00:09:56, Serial0/0
C 192.168.1.0/24 is directly connected, Serial0/0
C 192.168.2.0/24 is directly connected, FastEthernet0/0
O E2 192.168.100.0/24 [110/20] via 192.168.1.1, 00:09:55, Serial0/0
C 192.168.3.0/24 is directly connected, FastEthernet0/0
O E2 192.168.101.0/24 [110/20] via 192.168.1.1, 00:09:55, Serial0/0
Route-map config in FR:
access-list 1 deny 10.201.100.0
access-list 1 permit any
route-map eigrp2ospf permit 10
match ip address 1
!
route-map eigrp2ospf permit 20
match route-type internal
set metric 10
set metric-type type-1
!
route-map eigrp2ospf permit 30
match route-type external
set metric 50
set metric-type type-2
IS THE RESULT THAT I GOT CORRECT ????
THANK IN ADVANCE.
regards,
lee
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:47 GMT-3