From: Bryan Ginman (ginmanb@xxxxxxxxxxx)
Date: Fri Dec 21 2001 - 10:59:29 GMT-3
right one side only is it needed, and the load is calculated 1-255, 1 being
0% utilized and 255 being 100 percent loaded.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Frei Peter
Sent: Friday, December 21, 2001 6:14 AM
To: 'ccielab@groupstudy.com'
Subject: Multilink ppp, dialer load-threshold, snapshot routing
Hello all
I have read a lot of ISDN stuff, which sometimes says the opposite thing.
Like to hear your opinion.
Snapshot Routing and multilink ppp
All in one lab study guide: 1st edition p 125: Says that snapshot routing
does not work with multilink ppp. I tested it in my lab and had no problems.
Was there once an issue with it? Have IOS 12.1.11.
dialer load-threshold:
I thaugth the keyword either will use the higher load on inbound or outbound
tho calculate the load. Right? Did also read the addition of both at CCO.
Is the command needed on both side of the link? With keyword either it makes
for me no sense to put it on both.
Peter
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:46 GMT-3