From: Jason Gardiner (gardiner@xxxxxxxxxx)
Date: Tue Dec 11 2001 - 11:26:35 GMT-3
Depending on which router you issue this command, it could work (R3) or
not (R1). I prefer to use cle ip bgp <address> on either R3 or R1 or,
if you want a scenario where the routes aren't going to switch back in
30 seconds when the session comes back up:
router bgp xxxx
neighbor <R3 address> shutdown
"Phillip Estrada (EUS)" wrote:
>
> Dude, you're a senior network engineer?
>
> Clear ip bgp *
>
> -----Original Message-----
> From: Antonio Marfil [mailto:tony.marfil@networxcorp.com]
> Sent: Monday, September 10, 2001 3:33 PM
> To: ccielab@groupstudy.com
> Subject: Speeding up BGP convergance in Bootcamp lab 18
>
> In lab 18, task 4, item 9: Is there any way to speed up convergance?
>
> For example, r1 is dual homed to AS200 via r3 and r5. If I bring down r3,
> then it takes a couple of minutes for r1 to switch all of it's BGP routes to
> r5. can i make this happen isntantly or at least in a couple of seconds?
> --
>
> Regards,
>
> Antonio Marfil
> Senior Network Engineer
> NetworX Corporation
> http://www.networxcorp.com
> --
-- Thanks,Jason Gardiner Supervisor, Engineering Services Sprint <Insert Division Name>
"You can swim all day in the Sea of Knowledge and still come out completely dry. Most people do."
- Norton Juster
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:41 GMT-3