dialer watch and idle-timeout

From: tang bing (tang_bing@xxxxxxxxx)
Date: Sat Dec 08 2001 - 19:15:50 GMT-3

• Next message: Yonkerbonk: "Re:_Excessive_Broadcasts_on_Serial_links?"
• Previous message: tang bing: "Re: Which is better?..."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi,
While I was doing some reading with dialerwatch ,
CCO said : dialer-watch will check the watched-route
after every idle-timeout and if that route is still
missing , dialer-watch will clear idle-timeout and
keep the circuit up .
But when I did the config , I found this :
because ospf/eigrp hello are denied , so idle-timeout
will reset by them . when idle timed out , ISDN WAS
TEARED DOWN , and then ospf neighbor lost after
dead-interval (40 sec) , then route was removed from
routing table .
NOW , DIALER WATCH KICK ISDN UP AGIAN .

Is this the way dialer watch should work ?
or ???

thanks

Ben

• Next message: Yonkerbonk: "Re:_Excessive_Broadcasts_on_Serial_links?"
• Previous message: tang bing: "Re: Which is better?..."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:40 GMT-3