From: routerkid (routerkid@xxxxxxxxxxxx)
Date: Wed Dec 05 2001 - 18:54:25 GMT-3
If you want to disable routing for the IPX network number:
This is done at the process level... Use no network <ipx net #> under IPX
ROUTER RIP. When you do a sho run the IPX routing process will appear with
the negated network numbers..
Hope this is what you were looking for...
----- Original Message -----
From: Albert Lu <albert_ccie@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, December 05, 2001 5:06 PM
Subject: Making IPX RIP passive on certain interfaces
> Hello Group,
>
> Is it possible to make IPX RIP passive on interfaces like you can for IP
> RIP? I remember that there is an interface command that would allow this,
> rather than doing it through the routing process.
>
> Albert
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:39 GMT-3