From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Tue Dec 04 2001 - 19:16:59 GMT-3
Does anybody know what's OID for 5 min. input rate and 5 min output rate in
bit/sec. Following is output of sh int command. I am sure every counter in
this "shint" output has a OID for it but can't find it anywhere.
Thanks,
Sam Munzani
Serial0/0 is up, line protocol is up
Hardware is PQUICC with Fractional T1 CSU/DSU
Description: T1 Circuit ID xxxyyyzzz from Cust to Exodus-Oakbrook
MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
reliability 255/255, txload 3/255, rxload 155/255
Encapsulation FRAME-RELAY, loopback not set
Keepalive set (10 sec)
LMI enq sent 1, LMI stat recvd 1, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 1023 LMI type is CISCO frame relay DTE
Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:00:15
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/2/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 78000 bits/sec, 2 packets/sec
5 minute output rate 2000 bits/sec, 2 packets/sec
75 packets input, 4106 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
64 packets output, 6502 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:37 GMT-3