From: Brian Hescock (bhescock@xxxxxxxxx)
Date: Thu Nov 29 2001 - 12:06:54 GMT-3
In light of recent events, this disclaimer: I have not seen this on
any test nor have I heard it is on any test.
I've been going through "DLSw+ SAP/MAC Filtering Techniques" on CCO and
see where even if you have specified "dlsw mac-addr a.b.c remote-peer
ip-address x.x.x.x" it won't block the test frame to the peer that can
reach that mac. Apparently that's because the in the reachability cache
it's listed as "unconfirm". Is there a way to force it into "confirm"
state by adding another command somewhere or another way to filter a
test frame to a specifc host? I can filter all test frames to a
specific peer, no problem at all, but not to a specific host. And do
it without using "icanreach mac-exclusive" (pretend there are numerous
hosts out there and you don't know the mac's of all of them, which is a
more realistic scenario). Granted, this isn't something you would
normally do, I'm just trying to go beyond the basics and explore all
possibilities. Is it possible to block a SNA test frame destined to a
specific host? thx
Brian
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:25 GMT-3