RE: Is it okay to have 2 NAT Outside interfaces on the same router?

From: Andrew Lennon (alennon_uk@xxxxxxxxx)
Date: Wed Nov 28 2001 - 17:09:07 GMT-3


   
All,

I have been trying this for months! I have 2 dialer ints over a single
BRI set up to different ISP's and I want to policy route to some
internet destination addresses (ISP specific NNTP/SMTP stuff). I have
two pools and ACL's etc.

Whenever I bring up the 2nd connection the router hangs and reloads. I
have tried various IOS's from 12.0 through 12.2t on a 1603!

Theoretically it should work fine. In real life I am sick of watching
IOS reloads!

Regs,

Andy

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Courtney Alexander Foster
Sent: 28 November 2001 15:24
To: Davis, David; ccielab@groupstudy.com
Subject: RE: Is it okay to have 2 NAT Outside interfaces on the same
router?

should be fine...as long as you have a different NAT pool for each
one...

        -----Original Message-----
        From: Davis, David
        Sent: Wed 11/28/2001 9:00 AM
        To: ccielab@groupstudy.com
        Cc:
        Subject: Is it okay to have 2 NAT Outside interfaces on the same
router?
        
        

        In my configuration, I have two connections to the Internet,
each with
        an ip nat outside statement. My Ethernet interface on the
internal
        network has an ip nat inside statement.
        
        Is it okay to have two ip nat outside statements on different
interfaces
        on the same router?
        
        Thanks,
        David
        



This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:24 GMT-3