From: xander (xander@xxxxxx)
Date: Mon Nov 26 2001 - 07:39:06 GMT-3
Hello Albert,
Monday, November 26, 2001, 12:41:54 AM, you wrote:
AL> Hello Group,
AL> Just working through a practise lab at the moment, with solutions that don'
t
AL> look correct. Could someone confirm these solutions? (Don't worry, no NDA i
s
AL> being broken, as they are from a practise lab scenario)
AL> 1. Generate traps that are supported under the RFC for SNMP
AL> A. No idea. =) Suggestions please
It's generic snmp traps:
(config)#snmp enable traps snmp
(config)#snmp host 150.50.6.225 traps version snmp
AL> 2. Allow SNMP host 150.50.6.225 to access SNMP information from the devices
.
AL> A.
AL> access-list 10 permit 150.50.6.225
AL> snmp-server community test rw 10
It's valid if reqires ONLY one given host.
AL> 5. Configure DLSW between Token Ring segments on R1 and R8. Use IP address
AL> of the loopback interfaces for the DLSW peer-id with ring-group value of
AL> 4000
AL> Configure router R1 to block users from accessing SAP with a value of
AL> 012 <-----***** Not sure how to do this!!
dlsw icannotreach sap 012
AL> Adjust the following DLSW Netbios timers to 50,000 seconds on R1 and R8
:
AL> NetBIOS - cache-timeout
AL> NetBIOS - explorer-timeout
AL> NetBIOS - retry-interval
AL> Adjust the value of the LLC2 idle timer on TR segments on R1 and R8 to
AL> value of 60,000 <-----***** Not sure how to do this!!
llc2 idle-time 60000
-- WBW, xander CCNP Voice Access, AP1024-RIPE
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:22 GMT-3