From: Rivron Francois (Francois.Rivron@xxxxxxxxx)
Date: Thu Nov 22 2001 - 05:54:47 GMT-3
There are several ways ...but you need a router on each side on R1-TO et
R2-TO:
>Use LAT
lat service <service name> enabled
interface
lat enabled
lat node <name> !!default is router name
show lat services
show lat nodes
>Use dpsu
dspu host <name> rmac <@mac distante> lsap <dsap>
interface
dspu enable-host lsap <dsap>
dspu start <name>
>Use IPX encapsulation sap
Hope this help
> -----Message d'origine-----
> De: Rajeev Siddappa [SMTP:raj_lab@yahoo.com]
> Date: mercredi 21 novembre 2001 20:14
> @: ccielab@groupstudy.com
> Objet: DLSW Circuits
>
> Hi,
>
> I have a simple dlsw set up as follows.
>
>
> T0 ------ R1 --s0---- -----s0-- R2 ---- T0
>
> I can see that DLSW peers have connection
> established.
>
> I want to chek my circuits, but I donot have any end
> systems connected to my token ring network ( Token
> ring HUB).
>
> Is there any method by which I can establish circuit
> connection between the two token ring networks with
> out using any end stations.
>
> Thank you all in advance,
>
> Rajeev.
>
>
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:21 GMT-3