From: fwells12 (fwells12@xxxxxxxxxxx)
Date: Tue Nov 20 2001 - 15:16:16 GMT-3
Thanks for the reply. Your suggestions don't meet the requirements though.
To dial the peer you could only use 111. I want to be able to dial it using
any number of any length...if it can be done.
----- Original Message -----
From: "Andy Cuberly" <andyc@netcat.com>
To: "'fwells12'" <fwells12@hotmail.com>; <ccielab@groupstudy.com>
Sent: Tuesday, November 20, 2001 5:59 AM
Subject: RE: Can someone verify this voice config please.
> Almost there - You need to insert a single "." before the capital "T" in
the
> destination pattern in the VOIP dial peer.
>
> Looks like this:
>
> destination-pattern .T
>
> Also - You need to add a valid extension number in the Pots dial peer on
the
> destination pattern line.
>
> example:
>
> R1
> dial-peer voice 1 pots
> destination-pattern 111
> port 1/0/0
>
> dial-peer voice 2 voip
> destination-pattern .T
> session target ipv4:x.x.x.x (IP address of R2)
>
>
> The rest looks good.
>
> Andy Cuberly
> CCIE #8386
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> fwells12
> Sent: Tuesday, November 20, 2001 12:50 AM
> To: ccielab@groupstudy.com
> Subject: Can someone verify this voice config please.
>
>
> I don't have voice access to try this. The object of the excersize is to
be
> able to use any number to dial over frame-relay to another phone and have
> that
> phone be able to dial back using any number too.
>
>
> R1-----------frame-relay ------------R2
>
> R1
> dial-peer voice 1 pots
> destination-pattern T
> port 1/0/0
>
> dial-peer voice 2 voip
> destination-pattern T
> session target ipv4:x.x.x.x
>
> R2
> dial-peer voice 1 pots
> destination-pattern T
> port 1/0/0
>
> dial-peer voice 2 voip
> destination-pattern T
> session target ipv4:x.x.x.x
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:19 GMT-3