From: fwells12 (fwells12@xxxxxxxxxxx)
Date: Fri Nov 16 2001 - 20:35:26 GMT-3
I just connected two peers with DLSW Direct Encapsulation using the following
configs. Notice I did not use the 'broadcast' option on my frame-maps. The
sh dlsw peers still shows the peers as 'CONNECTED'. Now, I believe DLSW does
not use broadcasts to communicate, so I don't think the broadcast parameter is
necessary. Thoughts?
Note: I do not have any end points connected to verify this actually passes
traffic, but it looks promising.
R4
dlsw local-peer peer-id 139.5.4.4
dlsw remote-peer 0 frame-relay interface Serial0 403 pass-thru
interface Serial0
frame-relay map dlsw 403
R3
dlsw local-peer peer-id 139.5.3.3
dlsw remote-peer 0 frame-relay interface Serial0 304 pass-thru
interface Serial0
frame-relay map dlsw 304
r3#sh dlsw peers
Peers: state pkts_rx pkts_tx type drops ckts TCP
uptime
IF Se0 304 CONNECT 19 19 conf 0 - -
00:08:48
Total number of connected peers: 1
Total number of connections: 1
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:17 GMT-3