From: Jason Graun (jgraun@xxxxxxxxxx)
Date: Fri Nov 16 2001 - 11:32:04 GMT-3
If you want to modify the priority of a neighbor you must go to the
interface in which OSPF is running and issue "ip ospf priority" I have
had trouble using the other method "neighbor ip-address [priority
number] [poll-interval seconds]" however I had issues with 12.0 I
havent tried it yet in 12.1. Also you only need to issue the neighbor
command on one router. Preferably the hub router in this case. My best
suggestions is to try a minimal config and see it works, you might get
neighbors but they might not go to a full state, and/or you will get
full neighbors but no routes. Have fun.
I love OSPF
Jason
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
sanjay
Sent: Thursday, November 15, 2001 1:28 PM
To: Fred Ingham
Cc: ccielab@groupstudy.com
Subject: Re: OSPF -using Neighbor command
Thanks Fred. Will try you suggestion.
-Sanjay
----- Original Message -----
From: "Fred Ingham" <fningham@worldnet.att.net>
To: "sanjay" <ccienxtyear@hotmail.com>
Cc: <ccielab@groupstudy.com>
Sent: Thursday, November 15, 2001 10:36 AM
Subject: Re: OSPF -using Neighbor command
> Sanjay: No. You want the hub as the DR, so the neighbor statements
> only go on the hub. Spokes should be configured with ip ospf pri 0.
>
> General rule: OSPF neighbor statements only go on routers eligible to
> be DR
> or BDR.
>
> Cheers, Fred.
>
> sanjay wrote:
> >
> > I am working on a lab that requires me to use neighbor commands
instead
of the
> > usual 'ip ospf network ." I have one HUB router with a multipoint
interface
> > and 3 SPOKE routers across a Frame cloud. Does the neighbor
statement
need to
> > be on all the spoke routers stating the HUB as the neighbor.
> >
> > thanks,
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:17 GMT-3