From: Nigel Roy (nigel@xxxxxxxxxxxxxxxxx)
Date: Thu Nov 15 2001 - 11:28:38 GMT-3
----- Original Message -----
From: "Nigel Roy" <nigel@system-link.co.uk>
To: "Vincent Zhang" <vincentzhang@yahoo.com>
Sent: Thursday, November 15, 2001 2:19 PM
Subject: Re: EBGP session is not up when configured on spoke sites
> Vincent,
>
> Try putting the "neighbor update-source loopback X" on each neighbor.
>
> regards
>
> Nigel
> ----- Original Message -----
> From: "Vincent Zhang" <vincentzhang@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Thursday, November 15, 2001 11:46 AM
> Subject: EBGP session is not up when configured on spoke sites
>
>
> > Hi all,
> >
> > There are two spoke-site routers in hub-spoke FR environment, which
> configured
> > to be point-to-multipoint OSPF mode. When I want setup EBGP session
> between
> > the two routers, the session is not up. they remain in "active" status.
> >
> > The EBGP neighborship is configured on loopback IP addr on each routers
> with
> > "ebgp multihop", anybody here would show me a light?
> >
> > thanks, V
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:16 GMT-3