RE: EBGP session is not up when configured on spoke sites

From: Dennis #6 (vacant@xxxxxxxx)
Date: Thu Nov 15 2001 - 10:26:37 GMT-3

• Next message: Church, Chuck: "RE: Saving router costs"
• Previous message: Aaron DuShey-Yahoo: "Saving router costs"
• Maybe in reply to: Vincent Zhang: "EBGP session is not up when configured on spoke sites"
• Next in thread: Richard Foltz: "Re: EBGP session is not up when configured on spoke sites"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Can you ping each spoke from the other? Is there a route to the spokes in
the route table?

Dennis #6

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Vincent Zhang
Sent: Thursday, November 15, 2001 6:47 AM
To: ccielab@groupstudy.com
Subject: EBGP session is not up when configured on spoke sites

Hi all,

There are two spoke-site routers in hub-spoke FR environment, which
configured
to be point-to-multipoint OSPF mode. When I want setup EBGP session between
the two routers, the session is not up. they remain in "active" status.

The EBGP neighborship is configured on loopback IP addr on each routers with
"ebgp multihop", anybody here would show me a light?

thanks, V

• Next message: Church, Chuck: "RE: Saving router costs"
• Previous message: Aaron DuShey-Yahoo: "Saving router costs"
• Maybe in reply to: Vincent Zhang: "EBGP session is not up when configured on spoke sites"
• Next in thread: Richard Foltz: "Re: EBGP session is not up when configured on spoke sites"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:16 GMT-3