From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Fri Nov 09 2001 - 13:17:35 GMT-3
Group,
As I mentioned in my previous post, same config worked fine with 12.0.16.
*same configuration*. I tried the same config again on 12.1.5 code and
worked also. Conclusion: 12.1.11 code is buggy.
Tom
>From: dragi radovanovic <dragirad@yahoo.com>
>To: tom cheung <tkc9789@hotmail.com>
>Subject: Re: dialer profile problem
>Date: Fri, 9 Nov 2001 07:32:22 -0800 (PST)
>
>I think you need to give us your complete configs. The
>point made about the remote name in one of the replies
>is well made.
>Dragi
>
>
>--- tom cheung <tkc9789@hotmail.com> wrote:
> > Group,
> > I have this ISDN problem I couldn't figure out. R5
> > is setup to call R6,
> > things work fine when bri is configured using legacy
> > stuff. But just won't
> > work using dialer profile. Authentication went OK,
> > but R5 will immediately
> > send a disconnect. R5 is running 12.1.11, and R6
> > running 12.1.5 code. Maybe
> > someone can shed some light here?
> > Here's relevant config and debug output:
> >
> > --------- r5 ---------------
> > interface BRI0/0
> > no ip address
> > encapsulation ppp
> > dialer pool-member 1
> > isdn switch-type basic-ni
> > isdn spid1 3333
> > isdn spid2 4444
> > ppp authentication chap
> > ppp multilink
> > !
> > interface Dialer1
> > ip address 140.4.56.1 255.255.255.252
> > encapsulation ppp
> > ip ospf demand-circuit
> > dialer pool 1
> > dialer remote-name RACK01R5
> > dialer idle-timeout 60
> > dialer string 1111
> > dialer load-threshold 123 outbound
> > dialer-group 1
> > no cdp enable
> > ppp authentication chap
> > ppp chap hostname cisco5
> > ppp multilink
> >
> > --------------- r6 -------------------------
> > interface BRI0
> > ip address 140.4.56.2 255.255.255.252
> > encapsulation ppp
> > dialer idle-timeout 60
> > dialer map ip 140.4.56.1 name cisco5 broadcast
> > dialer load-threshold 125 outbound
> > dialer-group 1
> > isdn switch-type basic-ni
> > isdn spid1 1111
> > isdn spid2 2222
> > ppp authentication chap
> > ppp multilink
> >
> > ---------------- Debug from r5 ---------------
> > 00:12:58: %LINK-3-UPDOWN: Interface BRI0/0:1,
> > changed state to up
> > 00:12:58: %DIALER-6-BIND: Interface BR0/0:1 bound to
> > profile Di1
> > 00:12:58: BR0/0:1 PPP: Treating connection as a
> > callout
> > 00:12:58: BR0/0:1 PPP: Phase is ESTABLISHING, Active
> > Open
> > 00:12:58: BR0/0:1 CHAP: Using alternate hostname
> > cisco5
> > 00:12:58: BR0/0:1 LCP: O CONFREQ [Closed] id 9 len
> > 28
> > 00:12:58: BR0/0:1 LCP: AuthProto CHAP
> > (0x0305C22305)
> > 00:12:58: BR0/0:1 LCP: MagicNumber 0xD0646B7A
> > (0x0506D0646B7A)
> > 00:12:58: BR0/0:1 LCP: MRRU 1524 (0x110405F4)
> > 00:12:58: BR0/0:1 LCP: EndpointDisc 1 Local
> > (0x130901636973636F35)
> > 00:12:58: BR0/0:1 LCP: I CONFREQ [REQsent] id 62 len
> > 30
> > 00:12:58: BR0/0:1 LCP: AuthProto CHAP
> > (0x0305C22305)
> > 00:12:58: BR0/0:1 LCP: MagicNumber 0x0818E4FB
> > (0x05060818E4FB)
> > 00:12:58: BR0/0:1 LCP: MRRU 1524 (0x110405F4)
> > 00:12:58: BR0/0:1 LCP: EndpointDisc 1 Local
> > (0x130B015241434B30315236)
> > 00:12:58: BR0/0:1 LCP: O CONFACK [REQsent] id 62 len
> > 30
> > 00:12:58: BR0/0:1 LCP: AuthProto CHAP
> > (0x0305C22305)
> > 00:12:58: BR0/0:1 LCP: MagicNumber 0x0818E4FB
> > (0x05060818E4FB)
> > 00:12:58: BR0/0:1 LCP: MRRU 1524 (0x110405F4)
> > 00:12:58: BR0/0:1 LCP: EndpointDisc 1 Local
> > (0x130B015241434B30315236)
> > 00:12:58: BR0/0:1 LCP: I CONFACK [ACKsent] id 9 len
> > 28
> > 00:12:58: BR0/0:1 LCP: AuthProto CHAP
> > (0x0305C22305)
> > 00:12:58: BR0/0:1 LCP: MagicNumber 0xD0646B7A
> > (0x0506D0646B7A)
> > 00:12:58: BR0/0:1 LCP: MRRU 1524 (0x110405F4)
> > 00:12:58: BR0/0:1 LCP: EndpointDisc 1 Local
> > (0x130901636973636F35)
> > 00:12:58: BR0/0:1 LCP: State is Open
> > 00:12:58: BR0/0:1 PPP: Phase is AUTHENTICATING, by
> > both
> > 00:12:58: BR0/0:1 CHAP: Using alternate hostname
> > cisco5
> > 00:12:58: BR0/0:1 CHAP: O CHALLENGE id 5 len 27 from
> > "cisco5"
> > 00:12:58: BR0/0:1 CHAP: I CHALLENGE id 43 len 29
> > from "RACK01R6"
> > 00:12:58: BR0/0:1 CHAP: Using alternate hostname
> > cisco5
> > 00:12:58: BR0/0:1 CHAP: O RESPONSE id 43 len 27 from
> > "cisco5"
> > 00:12:58: BR0/0:1 CHAP: I SUCCESS id 43 len 4
> > 00:12:58: BR0/0:1 CHAP: I RESPONSE id 5 len 29 from
> > "RACK01R6"
> > 00:12:58: BR0/0:1 CHAP: O SUCCESS id 5 len 4
> > 00:12:58: BR0/0:1 PPP: Treating connection as a
> > callout
> > 00:12:58: %DIALER-6-UNBIND: Interface BR0/0:1
> > unbound from profile Di1
> > 00:12:58: BR0/0:1 PPP: Phase is VIRTUALIZED
> > 00:12:58: Vi1 PPP: Phase is DOWN, Setup
> > 00:12:58: BR0/0:1 PPP: Phase is TERMINATING
> > 00:12:58: BR0/0:1 LCP: O TERMREQ [Open] id 10 len 4
> > 00:12:58: %LINK-3-UPDOWN: Interface BRI0/0:1,
> > changed state to down
> > 00:12:58: BR0/0:1 LCP: State is Closed
> >
> >
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:11 GMT-3