From: Xuan.Sun@xxxxxxxxxxx
Date: Mon Nov 05 2001 - 18:13:04 GMT-3
In my practice, I just shut down the serial interface to clear up the
"inverse-arp". But you have to shut/no shut at both ends. It works fine for
me.
"Church, Chuck" <cchurch@USTA.com>@groupstudy.com on 11/05/2001 12:56:34 PM
Please respond to "Church, Chuck" <cchurch@USTA.com>
Sent by: nobody@groupstudy.com
To: "'ccielab@groupstudy.com'" <ccielab@groupstudy.com>
cc:
Subject: RE: When to reboot a router?
Those dynamic frame maps pointing to 0.0.0.0 need a reboot as well. 'Clear
frame' doesn't seem to help.
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Rahmlow, Howard F.
Sent: Monday, November 05, 2001 3:17 PM
To: 'Jerry Toomey'; ccielab@groupstudy.com
Subject: RE: When to reboot a router?
Two more - If you mess up an IP default network command. Only way to clear
the static routes it will create is to reload. Also to change a sub
interface from point-to-point to multipoint or the other way.
I'm sure there are a bunch more. If you put AppleTalk back in the mix,
reload often.
Howard
-----Original Message-----
From: Jerry Toomey [mailto:jetoomey@yahoo.com]
Sent: Monday, November 05, 2001 2:33 PM
To: ccielab@groupstudy.com
Subject: When to reboot a router?
Can any of you think of more scenarios that requires rebooting a router:
1. OSPF--if you add a second loopback, then reboot for the new process
ID.
2. ATM-- I've heard that sometimes you just have to reboot?
3. ?
=====
Jerry Toomey of http://www.wansend.com can be reached at 949-439-4685
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:04 GMT-3