From: Richard Foltz (ccie2b@xxxxxxxxxx)
Date: Mon Nov 05 2001 - 17:56:20 GMT-3
i have always found it good form to hard code router ids when possible, i.e.
OSPF, and BGP. it provides more stability and certainty within the network
cuz u always know what the ID is going to be no matter what you do later.
Richard Foltz, CCIE#8339, CCNP-Voice, CCDP, MCSE+I, Network+, A+
----- Original Message -----
From: "Joseph Ezerski" <jezerski@broadcom.com>
To: "'Jerry Toomey'" <jetoomey@yahoo.com>; <ccielab@groupstudy.com>
Sent: Monday, November 05, 2001 2:39 PM
Subject: RE: When to reboot a router?
> Given that the CCIE R&S lab will be using IOS 12.1 across the board, when
it
> comes to OSPF, why not manually nail down your RIDs under the OSPF
process.
> That way you cannot get screwed by the additon of a loopback with better
> numbers. Is anyone aware of any caveats doing it this way? I'd hate to
> find out during the lab ;)
>
> Ex:
>
> router ospf 1
> router-id 1.1.1.1
>
>
> -Joe
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Jerry Toomey
> Sent: Monday, November 05, 2001 11:33 AM
> To: ccielab@groupstudy.com
> Subject: When to reboot a router?
>
>
> Can any of you think of more scenarios that requires rebooting a router:
>
> 1. OSPF--if you add a second loopback, then reboot for the new process
> ID.
> 2. ATM-- I've heard that sometimes you just have to reboot?
> 3. ?
>
>
>
> =====
> Jerry Toomey of http://www.wansend.com can be reached at 949-439-4685
>
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:04 GMT-3