From: Chua, Parry (Parry.Chua@xxxxxxxxxx)
Date: Fri Nov 02 2001 - 05:49:57 GMT-3
Hi,
I do a quick test, R1 does not redistribute out the connected into RIP from
IGRP, the route from R2 (10.5.2.0) route appear at R3 with metric of 1
instead of 5 as stated in the config.
I create a several loopback at R2 and redistribute into igrp, these routes
appear at R3 with the correct metric.
May be someone can add in their experiences.
> Parry Chua
>
>
-----Original Message-----
From: Jing Jun Zhang [mailto:bjarmy@cisco.com]
Sent: Friday, November 02, 2001 3:30 PM
To: ccielab@groupstudy.com
Subject: Question about redistribution between igrp and rip
Boys and girls:
this question really makes me frustrated:
R2------R1------R3
the connection between router is serial HDLC link
subnet between r2 and r1 is 10.5.2.0/24
subnet between r3 and r1 is 10.6.2.0/24
r1 has one ethernet attached whose network is 192.168.10.0/24
r2 run igrp,r3 run rip,r1 run both igrp and rip,r1's configuration is
below:
router rip
redistribute igrp 1 metric 5
network 10.0.0.0
!
router igrp 1
redistribute connected
redistribute rip
default-metric 1000 100 255 1 1500
network 10.0.0.0
I thought r1's ethernet network will enter into igrp through
redistribute connected,will then redistribute to
rip,and r3 will see this network,but r3 can not see this
network,why,can you help
me?
Actually,it is one of troubleshooting problem in Jeff Doyle's TCP/IP
Volume1,it
is troubleshooting exercises No.1 in chapter 11.You can check it.
Regards
Jimmy ZhangJingJun
2001.11.1
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:01 GMT-3