From: Church, Chuck (cchurch@xxxxxxxx)
Date: Fri Oct 26 2001 - 11:16:07 GMT-3
Kevin,
Since the source IP is 10.1.1.6, I assume you're pinging from R6 to
R7. But you don't have a dialer map statement on R6. 'Sh dialer map'
should verify this.
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
kevin@btamail.net.cn
Sent: Friday, October 26, 2001 9:25 AM
To: ccielab@groupstudy.com
Subject: Ping doesn't work on isdn!!!
Hello all, I config ppp multilink on router with isdn port. isnd established
successfully. But ping
doesn't work. I debug ip packet. The following is shown:
02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, sending
02:06:31: IP: s=10.1.1.6 (local), d=10.1.1.7 (BRI0), len 100, encapsulation
fail
ed
Two router configuration for isdn as following:
r7#sh run int b0
Building configuration...
Current configuration:
!
interface BRI0
ip address 10.1.1.7 255.255.255.0
no ip directed-broadcast
encapsulation ppp
shutdown
dialer idle-timeout 300
dialer map ip 10.1.1.6 name r6 1111111
dialer load-threshold 128 outbound
dialer-group 1
isdn switch-type basic-net3
no peer neighbor-route
ppp multilink
end
r6#sh run int b0
Building configuration...
Current configuration:
!
interface BRI0
ip address 10.1.1.6 255.255.255.0
no ip directed-broadcast
encapsulation ppp
dialer idle-timeout 300
isdn switch-type basic-net3
no peer neighbor-route
ppp multilink
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3