From: Andre Santos (dredeze@xxxxxxxxxxx)
Date: Thu Oct 25 2001 - 16:10:07 GMT-3
do you have the router set as the pc's gateway
>From: "louie kouncar" <lkouncar@UU.NET>
>Reply-To: "louie kouncar" <lkouncar@UU.NET>
>To: "'Matt Wagner'" <miguknom@hotmail.com>, <vnthomas@hotmail.com>,
><ccielab@groupstudy.com>
>Subject: RE: Simple pinging problem
>Date: Thu, 25 Oct 2001 14:45:55 -0400
>
>Do you have any kind of firewall on the PC?
>
>
>
>Louie J. Kouncar CCIE #7994
>
>
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Matt Wagner
>Sent: Thursday, October 25, 2001 2:20 PM
>To: vnthomas@hotmail.com; ccielab@groupstudy.com
>Subject: Re: Simple pinging problem
>
>
>Do you have an ARP cache problem?
>
>
>
>----Original Message Follows----
>From: "Thomas, Varghese" <vnthomas@hotmail.com>
>Reply-To: "Thomas, Varghese" <vnthomas@hotmail.com>
>To: <ccielab@groupstudy.com>
>Subject: Simple pinging problem
>Date: Thu, 25 Oct 2001 14:14:53 -0400
>
>Hello folks,
>
>I connected a cross LAN cable between router's ethernet port and my
>PC(win2K);
>Problem is, I can NOT ping PC from router end, but I can ping the Router
>from PC end.
>
>router ip - 172.16.10.65/26 & PC's IP: 172.16.10.67/26
>
>Router's Sh arp command shows my PC's MAC & IP address correctly(I can very
>well see it from deb arp as well)
>
>When I turned on, debug ip packet, I can see the packets are being sent to
>ethernet interface, but it is not reaching my PC(as I don't see it in my
>PC's
>arp table) and nothing comes up in my sniffer.
>
>When I ping from PC, I can see correct ip packet sequences from router's
>debug
>output.
>
>I can even, telnet to the router from my PC via this cross cable, but
>again,
>pinging from the telenet session still fails.
>
>I do not see any output from deb ip icmp while I ping from router, but
>shows
>usual output when I ping from PC.
>
>Router do not have any special config and even I brought down all routing.
>
>When I replace my PC with another router(with the same cross cable), it
>works
>fine.
>
>I tried with different router models/ios and shows the same result.
>
>Any hints!!!
>
>
>Tx n RD
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:25 GMT-3