From: Yorgos Katsikogiannis (gkats@xxxxxxxxxxxxxx)
Date: Fri Oct 19 2001 - 08:11:25 GMT-3
Brian,
the confusion is made by two commands.
Backup load <enable-threshold>
Dialer load-threshold <load-threshold> either
<enable-threshold> = Values range from 1 - 100 => the actual percentage
<load-threshold> = Values range from 1 - 255 on the 256 - base.
After these, the answer should have been *backup load 50 25*
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/d
ial_r/drprt4/drdbaks.htm
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Diehm, Brian
Sent: Friday, October 19, 2001 5:36 AM
To: Ccielab (E-mail)
Subject: backup-load
Could somebody explain this math to me? I am working Fat kid 501
The requirement is bring the ISDN line up when the serial line reaches
50% utilization. Bring it down when the load on the Serial port falls
below 25%. The config show the answer as being backup load 50 10 I
don't get where they get the 10 from. Shouldn't that be a 25? Could
somebody explain this algorithm to me?
Thanks,
Brian D
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:22 GMT-3