From: Some Internet User (shadowd2@xxxxxxxxxxxxx)
Date: Wed Oct 10 2001 - 21:54:11 GMT-3
Ok, I was able to do a show cdp nei, learn the ip address, low and behold I
was able to telnet in with no password.
I happily typed out 'clear config all' and reset power to the switch.
Now the console port still isn't working... and I can't telnet in, what a
bummer...
I did however do a show before I blew away the config, not sure if this will
help or not:
Thanks in advance!
Enter password:
Console> (enable) sh config
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default configurations.
...........
.................
..
begin
!
# ***** NON-DEFAULT CONFIGURATION *****
!
!
#time: Thu Oct 11 2001, 00:39:34
!
#version 6.3(1)
!
set option fddi-user-pri enabled
!
#errordetection
set errordetection portcounter enable
!
#frame distribution method
set port channel all distribution mac both
!
#ip
set interface sc0 1 192.168.1.6/255.255.255.0 192.168.1.255
!
#set boot command
set boot config-register 0x101
set boot system flash bootflash:RTSYNC_cat5000-sup3_4-5-5.bin
set boot system flash bootflash:cat5000-sup3.4-5-2.bin
set boot system flash bootflash:RTSYNC_cat5000-sup3.45-1.bin
set boot system flash bootflash:RTSYNC_cat5000-sup3.45-1.bin
!
#igmp
set igmp disable
!
#mls
set mls nde disable
!
# default port status is enable
!
!
#module 1 : 2-port 10/100BaseTX Supervisor
!
#module 2 : 12-port 100BaseFX MM Ethernet
!
#module 3 : 12-port 10/100BaseTX Ethernet
set module name 3 jupiter
set port speed 3/1 10
set port name 3/1 jup1
!
#module 4 empty
!
#module 5 empty
end
Console> (enable)
Some Internet User wrote:
> Hello all, I picked up a catalyst switch on ebay... bought it from a guy
> in Australlia...
>
> the problem is, the switch looks like it boots up ok, but I'm not
> getting anything coming out of the console port.
>
> My console setup works on all my other routers/switches, but not on this
> cat5500 (with sup III).
>
> I've tried, 1200,2400,4800,9600, all the way on up.... the session shows
> connected, but banging on the return key outputs nothing.
>
> Any ideas/suggestions? Thanks in advance
>
> SM
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:16 GMT-3