From: Stanford M. Wong (stanford@xxxxxxxxxxxxxx)
Date: Wed Oct 10 2001 - 15:40:17 GMT-3
your vpi/vci has to be identical 1 33, 1 33 on both sides
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Don
Sent: Wednesday, October 10, 2001 8:10 AM
To: Groupstudy
Subject: ATM Help
I have two ATM MM cards connected back to back that I can't get either a
ping
or update traffic accross. I started a rip process on each but the other
side
doesn't see the update.
Debug atm pac
shows the update being queued and sent but the other side does not see it.
When I had clocking on one side I could get about 25% ping packets through
but
when I put clocking on both side nothing.
The reason I put clocking on both sides is because the interface was
bouncing,
hence the 25% success rate.
sh atm vc shows the vc active
I bought these cards on e-bay for about 500 each I hope I didn't get a bad
card.
Well here is my config, any ideas.
Thanks Don
interface ATM3/0/0
ip address 12.1.1.1 255.255.255.0
no ip route-cache distributed
map-group 1
atm clock INTERNAL
atm pvc 1 1 33 aal5snap
!
router rip
network 12.0.0.0
network 13.0.0.0
!
ip classless
!
!
map-list 1
ip 12.1.1.2 atm-vc 1 broadcast
logging buffered
interface ATM0
ip address 12.1.1.2 255.255.255.0
atm clock INTERNAL
atm pvc 1 1 34 aal5snap
map-group 1
!
router rip
network 12.0.0.0
network 14.0.0.0
!
ip classless
!
map-list 1
ip 12.1.1.1 atm-vc 1 broadcast
Thanks Don
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:16 GMT-3