From: Joseph Ezerski (jezerski@xxxxxxxxxxxx)
Date: Tue Oct 09 2001 - 15:01:57 GMT-3
Couple of Questions:
1. Is the link Point-to-Point or Point-to-Multipoint?
2. If so, are you using Frame-Relay Inverse ARP? (Do a "show frame map"
commmand)
3. Are all your PVCs listed as ACTIVE? (use "show frame pvc")
4. Have any IP addresses changed?
5. Have you tried rebooting?
List your configs and show commands here.
-Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Frank Kim
Sent: Tuesday, October 09, 2001 10:21 AM
To: ccielab@groupstudy.com
Subject: OT: Framerelay: layer 2 and layer 3
Hi guys,
I have an HQ and a remote office running frame-relay. Everything had been
working fine. It just started yesterday that I lost network connectivity
between the two sites. There was not any change in the config. All the
show frame pvi/lmi/map look good. In fact the two routers talk to each
other via CDP; they can see each other via CDP. So for sure, I know layer
2 is working. The problem is I cannot ping the interface back and
forth. Any help is appreciated. Thanks.
-Frank
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:16 GMT-3