From: Vikash Kalyan (KALYANV@xxxxxxxxxxxx)
Date: Sun Sep 16 2001 - 16:33:18 GMT-3
Markus,
MLS is relatively few commands, there are the commands that should
work.
For router .....
r(c)# mls rp ip - to enable mls globally
r(c-if)# mls rp vtp-domain <cat vtp domain name> - must specify this
command first else the router is put into the null domain and would not
work. To change the domain to the correct one would require that the all
the mls configs be reased and redond Iint the coreect order)
r(c-if)# mls rp vlan-id (vlan no.) - for external routers only to
inform interface which vlan it belongs to.
r(c-if)# mls rp ip - enable mls on interface
r(c-if)# mls rp management-interface - onlt required on one interface
of router. This interface will advertise to the CAT.
On Switch
set mls enable - this is the default and is therefore not required
set mls include (IP address of mamangement interface>
Thata it for the configs. Hope it helps.
Regards,
VK
>>> "Markus Haas" <mh@nmc-m.dtag.de> 9/16/01 1:15:33 PM >>>
Hi,
I try to setup MLS between an Cat5K and an external 7500er. I am using
dot1q
encap. on the trunk.
Have sombody useful links how to setup this scenario (sample config
etc.)
Thanks
Markus
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:19 GMT-3