From: Kyle Galusha (kgalusha@xxxxxxxxx)
Date: Mon Sep 03 2001 - 15:18:17 GMT-3
I believe if you are trying to be more precise with your byte count you
should use the following
queue-list 2 queue 1 byt-count 2048
queue-list 2 queue 2 byt-count 1024
queue-list 2 queue 3 byt-count 1024
Kyle
At 05:41 PM 9/3/2001 +0100, Muhammed Omar wrote:
>I'm doing the following Queue-List Example question. Could you advise if the
>solution is correct & if the DLSw+ and IP packet sizes have have any
>relevance:
>
>Question: Configure Router B's FDDI interface, such that:
>
>DLSw uses 50% bandwidth;
>
>IPX uses 25% bandwith;
>
>IP uses 25% bandwidth;
>
>DLSw packet size is 512 bytes. IP packet size is 1024 bytes. IPX packet size
>is 256 bytes.
>
>Answer: For Queueing this is what I think (not 100% sure what significant
>packet sizes have if any):
>
>ROUTERB(config)queue-list 2 protocol dlsw 1
>
>ROUTERB(config)queue-list 2 protocol ip 2
>
>ROUTERB(config)queue-list 2 protocol ipx 3
>
>ROUTERB(config)queue-list 2 queue 1 byt-count 3000
>
>ROUTERB(config)queue-list 2 default 4
>
>And apply on interface:
>
>ROUTERB(config-if)custom-queue-list 2
>
> So the implied total bandwidth is 6000 bytes (since 3 queues & 1st queue has
>been assigned higher bandwidth - 3000 bytes). Half goes to Q1 & the other 1/2
>is divided equally between the other 2 Qs.
>**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:14 GMT-3