From: Dotun Oni (dot_oni@xxxxxxxxxxx)
Date: Mon Sep 03 2001 - 14:23:46 GMT-3
Use the command "mac-address 1.1.1" on all your LAN interfaces.
D
>From: "Chris Allen" <chris.allen@callisma.com>
>Reply-To: "Chris Allen" <chris.allen@callisma.com>
>To: "kym blair" <kymblair@hotmail.com>, <ccielab@groupstudy.com>
>Subject: RE: IPX Node Address Question
>Date: Sun, 2 Sep 2001 13:35:59 -0400
>
>Using the command "ipx routing 1.1.1" only assigns the node address of
>1.1.1
>to non-MAC interfaces (i.e. Serial). I would guess that if you wanted all
>node addresses on the router to be 1.1.1, you would change the MAC address
>on each LAN interface to 1.1.1... Correct me if I am wrong anybody???
>
>
>Chris
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>kym blair
>Sent: Saturday, September 01, 2001 11:25 PM
>To: ccielab@groupstudy.com
>Subject: IPX Node Address Question
>
>
>To avoid using the MAC address as the IPX address, I use "ipx routing
>1.1.1"
>(on Router 1). Under the interface, "ipx network 11". On remote routers
>"show ipx route" sometimes shows 11.0001.0001.0001, and sometimes shows
>11.0000.302b.34ae.
>
>How can I ALWAYS assign the IPX router ID as 1.1.1?
>
>Question 2: I am able to ping ipx 11.1.1.1 if it's ipx address was
>propegated as 11.1.1.1, but when it is propegated with it's MAC, I can't
>ping 11.0000.302b.34ae from distant routers. How can I ping every IPX
>address from anywhere in the network?
>
>Thanks, Kym.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:14 GMT-3