From: Chuck Church (cchurch@xxxxxxxxxxxx)
Date: Sun Sep 02 2001 - 11:12:01 GMT-3
Daniel,
I'm not sure if Cisco considers it a bug, but that how it works
sometimes. It doesn't happen all the time, so I'm thinking that the order
you configure your routers in has an effect. Try keeping both sides of the
PVC administratively down until you get both addressed, and any frame map
statements in there. The 'no sh' both sides at about the same time. What I
think happens is one side Inverse arps to the other side, the other side
isn't IP addressed yet, even though the PVC is up. So is just uses this
0.0.0.0 address. Can anyone verify this?
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Daniel Hong
Sent: Sunday, September 02, 2001 7:52 AM
To: ccielab@groupstudy.com
Subject: FR inverse arp
Hi Group,
I experienced a strange thing on a FR interface. The fr inverse arp result
a 0.0.0.0 ip address.
I tried clear fr inverse-arp, shut down the interface.... Couldn't fix the
problem.
at the end, I reloaded the router, problem is fixed.
the System image file is "flash:c3640-js-mz.121-5.T8.bin"
r2#sh fram map
Serial0/0 (up): ip 0.0.0.0 dlci 101(0x65,0x1850)
broadcast,
CISCO, status defined, active
Serial0/0 (up): ipx 20.0003.6b73.09e0 dlci 101(0x65,0x1850), dynamic,
broadcast,, status defined, active
Did I missed something or it's a bug.
Regards
Daniel
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:13 GMT-3