From: Gregory W. Posey Jr. (gposey@xxxxxxxxxxx)
Date: Wed Aug 15 2001 - 22:37:37 GMT-3
Did you configure the "area 1 range" command on R3 as well as R2 (since with
the virtual link, R3 is an ABR that touches Areas 0, 1 & 2)?
Thank you,
Greg Posey Jr.
CONECTS Network Analyst
CCIE #7981
CCDA/CCNP - Security Specialist
Cisco Voice Access Specialist
313-875-2088 ext. 347
www.conects.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ashok Sud
Sent: Wednesday, August 15, 2001 9:25 PM
To: ccielab@groupstudy.com
Subject: OSPF summarization fail when virtual link is configured
Hi Group,
Can someone please explain the reason for the following observation.
Scenario:-
area 0 area 1 area2
R1------------------R2--------------------R3----------------------R4
R2 is the ABR for area 1 and is summarizing networks in area 1 with area
range command. The summary route can be observed in R1's routing table. R2
has number of interfaces connected to other routers in area 1 but is left
out of the diagram.
When I configure a virtual link between R2 and R3, I can observe all the
networks in area 1 in the routing table of R1 along with the summary route.
Is it a normal behaviour or am I missing something?
Thanks
Ashok
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:51 GMT-3