From: Sandro Ciffali (sandyccie@xxxxxxxxx)
Date: Sun Aug 12 2001 - 15:02:51 GMT-3
Thanks all who replied to me querry,
I used the priority and it works fine, I did not know that neighbor priority
does not work for the multipoint interface, The strange thing is it modifies
the running config, Hence if you do not pay attention and make some other
changes and do a write mem this new config is written in the nvram, I
thought i was drunk to see my config changing again and again.
Once again thanks for the help
Sandro
----- Original Message -----
From: "Kyle Galusha" <kgalusha@cisco.com>
To: "Sandro Ciffali" <sandyccie@yahoo.com>
Cc: <ccielab@groupstudy.com>
Sent: Sunday, August 12, 2001 12:21 PM
Subject: Re: Ospf NBMA strange experience
> Try using "ip ospf priority XXX" on the interface no as part of the
> neighbor command. Make r3 interface a higher value and/or make r5 and r2
> values a 0. I don't believe the priority value works for the neighbor
> statement on a point to multipoint interface.
>
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_r
/1rprt1/1rospf.htm#xtocid677225
> Kyle
>
>
>
> At 08:56 AM 8/12/2001 -0700, Sandro Ciffali wrote:
> >I am trying following in my tes bed.
> >
> >Routers R2, R3 and R4 connected with frame. R3 is a
> >hub with a physical interface to the frame, R2 is
> >through the subinterface and R4 is through physical
> >interface connected to the frame. The frame network is
> >NBMA. I have tried following to make R3 DR.
> >
> >Try 1)
> >Configure following line under ospf on R2
> >neighbor ip_address_R3 priority 10
> >Also under subinterface i have ip ospf network
> >nonbroad
> >Under R4 ospf statements I have
> >neighbor ip_address_R3 priority 10 and ip ospf net
> >nonbroad for the interface
> >Under ospf of R3 I have
> >neighbor ip_address_R2 priority 0
> >neighbor ip_address_R4 priority 0
> >
> >When i do this the highest ip address becomes the DR,
> >the funny thing is now when i check my running configs
> >my neighbor statements are different,
> >On R3 i see sh run as
> >neighbor ip_address_R2 priority 1 and ip_address_R4
> >priority 1. My show startup-config is still the
> >original that i configrured (With 0 priority)
> >
> >It does not stop here on R2 which is chosen as the DR
> >My neighbor statement changes from priority 50 to
> >priority 1 again in the running config only not in the
> >startup config. Same happens on R4 also.
> >
> >Any suggestions???
> >
> >Sandro
> >
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:49 GMT-3