From: Dan Pontrelli (dp595@xxxxxxxxxxxxx)
Date: Sun Jul 29 2001 - 22:26:13 GMT-3
A reboot did the trick.
Thanks.
-DP
> Try ..
>
> config t
> logging monitor debugging
> end
>
>
> JONC
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Dan Pontrelli
> Sent: Sunday, July 29, 2001 5:18 PM
> To: ccielab@groupstudy.com
> Subject: "Terminal monitor" not working
>
>
> I'm running debug commands, but only can view the output if I'm on the
> console.
> I'm not able to view it during a telnet session, even though I've used the
> "terminal monitor" command.
> Does anyone have a suggestion? I've never had this problem before.
Terminal
> monitor always does it.
> I'm running 12.2 on a 2514
>
> 2514(config)#int e0
> 2514(config-if)#no ip route-cache
> 2514(config-if)#^Z
> 2514#
> 2514#term monitor
> 2514#s deb
> Generic IP:
> IP packet debugging is on (detailed)
> 2514#ping www.yahoo.com
> Translating "www.yahoo.com"...domain server (167.206.112.4) [OK]
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 64.58.76.179, timeout is 2 seconds:
> !!!!!
> Success rate is 100 percent (5/5), round-trip min/avg/max = 20/26/44 ms
> 2514#
>
>
> No logging info follows like it usually does.
> **Please read:http://www.groupstudy.com/list/posting.html
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:49 GMT-3