Re: Load threshhold 1 keeps the line flapping!!

From: Stuart Mark (stuart_mark@xxxxxxxxxxxxxxxx)
Date: Mon Jun 11 2001 - 11:58:12 GMT-3

• Next message: Patrick Murphy: "Re: Successful PPP Callback?"
• Previous message: Shane Miles: "Token Ring hardware error"
• Maybe in reply to: Dirar Hakeem: "Load threshhold 1 keeps the line flapping!!"
• Next in thread: Mas Kato: "RE: Load threshhold 1 keeps the line flapping!!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Perhaps this will help (from the UniverCD)

"The load threshold number is required. For an example of configuring
Multilink PPP on a single ISDN BRI interface, see the "Multilink PPP on One
ISDN Interface Example" section later in this chapter."

"When Multilink PPP is configured and you want a multilink bundle to be
connected indefinitely, use the dialer idle-timeout command to set a very
high idle timer. (The dialer-load threshold 1 command no longer keeps a
multilink bundle of n links connected indefinitely and the dialer-load
threshold 2 command no longer keeps a multilink bundle of two links
connected indefinitely.)"

The link is :

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_
c/dcppp.htm#5318

Stuart
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Patrick Murphy: "Re: Successful PPP Callback?"
• Previous message: Shane Miles: "Token Ring hardware error"
• Maybe in reply to: Dirar Hakeem: "Load threshhold 1 keeps the line flapping!!"
• Next in thread: Mas Kato: "RE: Load threshhold 1 keeps the line flapping!!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:22 GMT-3