From: louie kouncar (lkouncar@xxxxxx)
Date: Thu Jun 07 2001 - 20:54:38 GMT-3
Your problem is that you are using R5 in the username but r5 in the
config.(USE A CAPITAL R) in the configs.....
That should fix the problem....
Louie K
UUNET
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
sanjay
Sent: Thursday, June 07, 2001 5:33 PM
To: Cal Michael; ccielab@groupstudy.com
Subject: Re: ISDN Troubles
Yep. I have
> R3(config)#username R5 password <password>
> R5(config)#username R3 password <password>
thanks
Sanjay
----- Original Message -----
From: "Cal Michael" <cmichael@network-data.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, June 07, 2001 1:53 PM
Subject: RE: ISDN Troubles
> - Since this is not in the provided config,
> and you are using a config with ppp chap
> authentication with a user specified.
>
> R3(config)#username R5 password <password>
> R5(config)#username R3 password <password>
>
> --- ----- ---
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> sanjay
> Sent: Thursday, June 07, 2001 3:35 PM
> To: ccielab@groupstudy.com
> Subject: ISDN Troubles
>
>
> Hi,
>
> I have 2 routers accross an ATLAS 800 ISDN SIM and when I try to ping from
> one
> to another, it doesn't ping. Below is the output of debug dialer and it
> seems
> that the problem is with the carrier timeout. Has anyone seen this before
> and
> perhaps recommend on what may be going on. I have also included the output
> of
> show isdn stat and everything there seems to be o.k. Any suggestion is
> appreciated and thanks in advance.
>
>
>
>
> r3#ping 192.168.1.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
>
> 19:10:29: BRI0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
> 19:10:29: BRI0/0 DDR: Attempting to dial 8895201
> 19:10:29: BRI0/0: wait for isdn carrier timeout, call id=0x803D
> 19:10:29: BRI0/0:1 DDR: disconnecting call.
> 19:10:31: BRI0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
> 19:10:31: BRI0/0 DDR: Attempting to dial 8895201
> 19:10:31: BRI0/0: wait for isdn carrier timeout, call id=0x803E
> 19:10:31: BRI0/0:1 DDR: disconnecting call.
> 19:10:33: BRI0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
> 19:10:33: BRI0/0 DDR: Attempting to dial 8895201
> 19:10:33: BRI0/0: wait for isdn carrier timeout, call id=0x803F
> 19:10:33: BRI0/0:1 DDR: disconnecting call.
> 19:10:35: BRI0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
> 19:10:35: BRI0/0 DDR: Attempting to dial 8895201
> 19:10:35: BRI0/0: wait for isdn carrier timeout, call id=0x8040
> 19:10:35: BRI0/0:1 DDR: disconnecting call.
> 19:10:37: BRI0/0 DDR: Dialing cause ip (s=192.168.1.2, d=192.168.1.1)
> 19:10:37: BRI0/0 DDR: Attempting to dial 8895201
> 19:10:37: BRI0/0: wait for isdn carrier timeout, call id=0x8041
> 19:10:37: BRI0/0:1 DDR: disconnecting call.
> Success rate is 0 percent (0/5)
> r3#
>
>
> r3#sh isdn stat
> Global ISDN Switchtype = basic-ni
> ISDN BRI0/0 interface
> dsl 0, interface ISDN Switchtype = basic-ni
> Layer 1 Status:
> ACTIVE
> Layer 2 Status:
> TEI = 65, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
> TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
> Spid Status:
> TEI 64, ces = 1, state = 8(established)
> spid1 configured, spid1 sent, spid1 valid
> Endpoint ID Info: epsf = 0, usid = 70, tid = 1
> TEI 65, ces = 2, state = 8(established)
> spid2 configured, spid2 sent, spid2 valid
> Endpoint ID Info: epsf = 0, usid = 70, tid = 2
> Layer 3 Status:
> 0 Active Layer 3 Call(s)
> Activated dsl 0 CCBs = 0
> The Free Channel Mask: 0x80000003
> Total Allocated ISDN CCBs = 0
> r3#
>
> !
> interface BRI0/0
> ip address 192.168.1.2 255.255.255.0
> no ip directed-broadcast
> encapsulation ppp
> dialer idle-timeout 90
> dialer map ip 192.168.1.1 name r5 broadcast 8895201
> dialer load-threshold 1 outbound
> dialer-group 1
> isdn switch-type basic-ni
> isdn spid1 5101 8895101
> isdn spid2 5102 8895102
> ppp authentication chap
> ppp multilink
> **Please read:http://www.groupstudy.com/list/posting.html
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:20 GMT-3