From: Arthayuth.B@xxxxxxxxxxxxxxxxxx
Date: Tue Jun 05 2001 - 02:42:54 GMT-3
I think my answer look like same as Nafie written but I would like to add
set AD for ospf higher than routing proticol that added in area 1.
-----Original Message-----
From: Khalid Nafie [mailto:knafie@ncr.com.kw]
Sent: Tuesday, June 05, 2001 3:27 PM
To: BootCamp; Buddy Venne
Subject: RE: Challenge Question
configure any other routing protocol in on the ABR of area 1 then
redistribute andredistribute back.
================================================
Yours,
Khaled Nafie
Network Engineer
Customer Services
MCSE,CCDP,CCNP VOICE ACCESS
NCR Corporation, Kuwait
Mob.: +965-9872046
Tel : +965- 2412201, 2412203
Fax : +965-2413075
> ----------
> From: Buddy Venne[SMTP:Buddy.Venne@ONYXCO.com]
> Reply To: Buddy Venne
> Sent: Tuesday, June 05, 2001 7:58 AM
> To: 'ccielab@groupstudy.com'
> Subject: Challenge Question
>
> I have a challenge question: (there is at least one solution)
> Q.) When you link ospf area 0 and area 1, how do I make the routes from
> area 1 show up as external type 1 on the area 0 router? You are "linking"
> the two areas in the normal way, with an ABR.
>
> No static routes
> OSPF must remain running in area 1. Disabling it would ruin the question.
> You can't make area 1 an area 1 in a different ospf process.
> You can do basically anything else.
>
> Bud Venne, CCNP/SS
> WAN/LAN Specialist
> Onyx Acceptance
> (949) 465-3775
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:18 GMT-3