From: Rob Webber (rwebber@xxxxxxxxxxxx)
Date: Thu May 31 2001 - 09:29:09 GMT-3
source-bridge spanning applies SRB spanning tree (i.e., IBM spanning tree)
to an SRB environment. All Route (or all path) Explorers are unaffected by
this - they will travel over all routes. Single Route Explorers or Single
Path Explorers will only travel on the paths that are forwarding by the IBM
spanning tree.
The end station determines what type of explorer - all route or single
route - to send, thus there is no "default" for the type of explorer they
will send. This really depends on the application and/or end station.
Rob.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Haohong Lin
Sent: Wednesday, May 30, 2001 10:28 PM
To: CCIELab
Subject: source-bridge spanning
'source-bridge spanning' uses for spanning-tree exploerer, default mode is
all paths explorer.
is that right?
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:57 GMT-3