From: Curtis Call (curtiscall@xxxxxxxx)
Date: Sun May 27 2001 - 15:52:05 GMT-3
I'm afraid I have to differ with you on this one, but I'm doing so from
theory, I'll have to test this out in the lab on Monday. A virtual link
just transports routing information. When you setup a virtual link on your
router and so a show interfaces, do you see a "tunnel" interface for your
virtual link? I am assuming the answer is no, again when you debug ip
packets do you see them being sent on the virtual link? Once again, I
believe the answer is no. (But I have no routers to test this on at the
moment).
If a virtual link was a tunnel then there would be no requirement for a
transit area to not be a stub area. Since all traffic going over the link
would be encapsulated the routers in that particular area wouldn't need to
know how to reach any routers other than the two ABRs that made up the
virtual link and that are present in the area. However, given that a
virtual link is not a tunnel and is solely a transport of routing
information all packets will be sent hop by hop through the transit area,
that's why that area must have full routing information of the OSPF domain.
At 11:38 AM 5/27/01, you wrote:
>Hi Curtis,
>
>RFC states that all OSPF areas must be connected to area 0. A virtual link
>provides a transparent connection through another area (which must itself
>be connected to area 0) to area 0. This kind of 'virtual connection'
>concept is known as tunnelling; same as DLSW, IPX, IP over IP, VOIP
>tunnels.
>
>Regards,
>
>Eugene
>
>Curtis Call <curtiscall@home.com> wrote:
>Traffic from R2 to R1 will go directly from R2 to R1. Remember that in
>order to have R2 be a virtual link it will have an interface in Area 1,
>therefore to reach any destination in Area 1 it will always use the
>intra-area route. Besides, Virtual Links are not tunnels, you can't
>transport traffic over them, they just carry routing information, the
>traffic still goes hop by hop throughout the OSPF domain.
>
>At 12:54 AM 5/25/01, you wrote:
> >Guys,
> >
> >I wonder if their is anybody who remembers the discussion on Virtual
> >Links in OSPF. It was posted some time ago but I can't seem to find it.
> >
> >The scenario was something like this:
> >________ _______ _______
> >|Area 0| |Area1| |Area2|
> >| R0 |--| R1 |--| R2 |
> >|______| |_____| |_____|
> >
> >There is a virtual link from area 2 to Area 0 via Area1. Traffic needs to
> >get to R1 in Area 1 from R2 in Area 2. Assume that the virtual link has to
> >use R1 (To create the V.Link). Does the traffic flow passed R1 (in Area 1)
> >to Area 0 and then back to area 1, or does the actuall flow just to R1
> from R2.
> >
> >I cant remember the conclusion, and I cant seem to find it on the
> >archives. Quite interesting issues.
> >
> >Regards,
> >Andy
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:54 GMT-3