In DLSW, Purpose of dest-mac or dmac-output-list

From: Joe Shmoe (herro91@xxxxxxxxx)
Date: Tue May 22 2001 - 17:53:31 GMT-3

• Next message: emonk@xxxxxxx: "Re: IPX DDR Q'"
• Previous message: Himawan Nugroho: "wildcard mask for eigrp"
• Next in thread: Pickell, Aaryn: "RE: In DLSW, Purpose of dest-mac or dmac-output-list"
• Maybe reply: Pickell, Aaryn: "RE: In DLSW, Purpose of dest-mac or dmac-output-list"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
After reading the DLSw+ design guide, I'm a little
confused about this one.

When configuring either dest-mac or dmac-output-list
in the dlsw remote peer command :
(ex: dlsw remote-peer 0 tcp 1.1.1.1 dest-mac a.b.c),

is this command meant to advertise to the remote peer
that a specific mac address or multiple mac addresses
are accessible/inaccessible via this local router,
that is they are local to this router?

Or, does it mean that the resources actually exist on
the remote peer?

Any advice...Thanks...

• Next message: emonk@xxxxxxx: "Re: IPX DDR Q'"
• Previous message: Himawan Nugroho: "wildcard mask for eigrp"
• Next in thread: Pickell, Aaryn: "RE: In DLSW, Purpose of dest-mac or dmac-output-list"
• Maybe reply: Pickell, Aaryn: "RE: In DLSW, Purpose of dest-mac or dmac-output-list"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:49 GMT-3