From: Himawan Nugroho (nhimawan@xxxxxxxxxx)
Date: Sun May 20 2001 - 23:17:53 GMT-3
I believe we can use the ' summary-range' command in ASBR...even in
reference, this command is used to summary from outside to inside OSPF, and
not vice-versa..
is it correct?
Regards,
Himawan Nugroho
Network Solutions Specialist
IBM Global Services - Indonesia
Voice : 62-21-5238897, Fax : 62-21-2512933
"Roman Rodichev" <rodic000@hotmail.com>@groupstudy.com on 05/21/2001
09:02:52 AM
Please respond to "Roman Rodichev" <rodic000@hotmail.com>
Sent by: nobody@groupstudy.com
To: dma@cisco.com, ccielab@groupstudy.com
cc:
Subject: Re: another redistribution question
nice question. You are right, if you configure "area 0 range" on the ASBR,
IGRP will not redistribute it. Redistribute command simply looks in the
routing table and takes all routes that are marked "O" (for OSPF) and then
applies FLSM rules. But obviously, if you got "area 0 range" on the ASBR,
it
will not have that route in the table (EIGRP will). So, you can either:
1. do "area 0 range" on another router, so then the ASBR would have the
summary in the routing table.
2. or create a static route to null0 on ASBR and redistribute static into
IGRP
Roman
>From: David Anderson <dma@cisco.com>
>Reply-To: David Anderson <dma@cisco.com>
>To: ccielab@groupstudy.com
>Subject: another redistribution question
>Date: Sun, 20 May 2001 18:24:04 -0700
>
>Ok, here is my redistribution question:
>
>Suppose I have an OSPF area (say area 0) with a /28 mask and I am
>redistributing with IGRP which has a /24 mask. Can one summarize the area
>0 using the area range command on the ASBR? I tried and could not get it
>to work. However, what I did get to work was to create a loopback on
>another router in my ospf domain using the same subnet I have in my area
0,
>but with a /24 mask and then advertised that into ospf and all was well on
>the IGRP router. I could ping all of my /28 ospf interfaces. Does anyone
>have any suggestions other than this? Did I miss anything?
>
>Thanks everyone,
>David
>David Anderson
>Network Design Engineer
>Enterprise Solutions Architecture & Design
>(408) 853-5515
>dma@cisco.com
> | |
> ..:|||||||:...:|||||||:..
>C I S C O S Y S T E M S
>**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:47 GMT-3