DLSW+ bgroup command

From: Kurt Bergsbaken (kbergsbaken@xxxxxxxxxx)
Date: Wed May 16 2001 - 13:43:33 GMT-3

• Next message: Ewing, James: "lab swap"
• Previous message: Dean, Justin: "FW: Bootcamp Lab 8 Demand Circuit question"
• Next in thread: Mike Schlenger: "RE: DLSW+ bgroup command"
• Maybe reply: Mike Schlenger: "RE: DLSW+ bgroup command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Can anyone help me understand when to use, and how to apply the dlsw bgroup-li
st command?

Would this be useful if there were 2 vlans, vlan a has 2 ethernet attached rout
er interfaces, then across the ip cloud vlan b had the same. If the 4 interface
s need to establish peer connectivity, can this be done without the border stat
ement or without a full mesh. Does
the bgroup list command help here, and what would the config look like? I have
 not found a single sample config in any of the Cisco Press books, or on the CD
, that uses this command.

                                                        Thanks
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Ewing, James: "lab swap"
• Previous message: Dean, Justin: "FW: Bootcamp Lab 8 Demand Circuit question"
• Next in thread: Mike Schlenger: "RE: DLSW+ bgroup command"
• Maybe reply: Mike Schlenger: "RE: DLSW+ bgroup command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:42 GMT-3