From: Andrew Chong (achong@xxxxxxxxxxxxxx)
Date: Wed May 16 2001 - 08:28:21 GMT-3
Zeng,
icanreach command tell your peers about your supported SAPs so that remote
peers only send connection request to the SAPs you state in the "icanreach"
command.
remote-peer lsap-output-list allow or deny SAPs from leaving the local
router according to access-list 2xx.
Which one to use depends on the situation. For example , use icanreach SAP
at central site to control access from all remote sites. Use
lsap-output-list to filter SAPs to a particular remote-site.
andrew
----- Original Message -----
From: "Zeng Puyang" <zbridge98@yahoo.com>
To: "ccielab" <ccielab@groupstudy.com>
Sent: Wednesday, May 16, 2001 8:33 PM
Subject: dlsw: diffirent between 'icanreach sap' and 'remote-peer
lsap-output-list' ?
> Hi, group:
>
> If I want to permit only netbios traffic between R1 and R2 dlsw peer,
what's the diffirent between using 'icanreach 0xF0' and remote-peer
lsap-output-list? Do the two command can chieve the same effect?
>
>
> Zeng
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:42 GMT-3