From: tommyhu (tommyhu@xxxxxxxxxxxxxxxx)
Date: Wed May 16 2001 - 00:40:26 GMT-3
Hello Guys,
a2sbc> 1. use a dot1q trunk on both end if your trunking
a2sbc> 2. Don't use Vlan1 and this passes management traffic to the 3com, I kno
w
a2sbc> Bay switches don't like this
a2sbc> other than this I haven't had a problem
a2sbc> Andrew Shore
a2sbc> BTcd
a2sbc> IDC Technical Specialist
>> ignite Content Hosting
a2sbc> -----Original Message-----
a2sbc> From: tommyhu [mailto:tommyhu@wafersystems.com]
a2sbc> Sent: 15 May 2001 10:47
a2sbc> To: ccielab@groupstudy.com
a2sbc> Subject: If Cisco 2924XL can connect with 3COM LinkSwitch 3000 ?
a2sbc> Hello Guys,
a2sbc> I have Cisco 2924XL and 3COM linkswitch 3000 ,but when I
a2sbc> connect them with a 100Base-Tx(crossover cable), the station on both
a2sbc> Catalyst 2924XL working is fine and on both 3Com LinkSwitch 3000 too. B
ut
a2sbc> when
a2sbc> one PC inserted in 2924 ping other PC inserted in LS3000, the
a2sbc> performance is very poor , the loss packet rate is very high and
a2sbc> delay is very long.
a2sbc> I think these two product should can connect together.But maybe need
a2sbc> revise some default parameter , Pls tell me how to revise?
a2sbc> Thanks.
Last day, I try many ways to solve the problem which include change
the default configuration in LinkSwitch3000.I change the
parameter:Intellegent flow management to disable and speed,duplex to
the same to Catalyst 2924xl, but problem do not solve.
Late, I discovery the port status in Lk3000 has many CRC errors, I
think it would be cable problem. I ask my fellow to change the
cable,(because the switch is in other province)then problem solved.
Thanks everyone who help me!
-- Best regards, tommyhu mailto:tommyhu@wafersystems.com **Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:42 GMT-3