From: R. Benjamin Kessler (ben@xxxxxxxxxxxxxxxxxxxxx)
Date: Wed May 02 2001 - 09:22:59 GMT-3
Check-out the following link:
http://127.0.0.1:8080/cc/td/doc/product/access/acs_fix/cis2500/2509/acsvrug/
maint.htm#xtocid1285317
or
http://cco.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2509/
acsvrug/maint.htm
Then click on:
"Virtual Configuration Register Settings"
This gives the details on what all of the bits on the config register mean.
It doesn't go by the menu that you included but you should be able to get
the drift for most of these.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Devender Singh
Sent: Monday, April 30, 2001 4:29 AM
To: Ccielab@Groupstudy. Com (E-mail)
Subject: Basic confreg
Hai all,
I wish input from you guys, on the following in ROM mode:
do you wish to change the configuration? y/n [n]: y <---- Obvious
enable "diagnostic mode"? y/n [n]: <------Never used it.
don't when should be used. Maybe when be suspect hardware problem with the
router
enable "use net in IP bcast address"? y/n [n]: <----- No idea this one
is.
disable "load rom after netboot fails"? y/n [n]: <----- Obvious
enable "use all zero broadcast"? y/n [n]: <----- when will I use
all zero broadcast
enable "break/abort has effect"? y/n [n]: <----- enable effect
of break at any time not only on boot
enable "ignore system config info"? y/n [n]: <----- Obvious
change console baud rate? y/n [n]: <-- obviuos
change the boot characteristics? y/n [n]: <---- what's this.
best regards
Devender Singh
BE(Hons), CCNP
IP Solution Specialist
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:32 GMT-3