From: Martin, Chris (chris@xxxxxxxxxxxx)
Date: Tue May 01 2001 - 11:17:00 GMT-3
Roger if you look at your sh isdn st command you have 0 layer 3 calls.
Also i dont see a encapsulation ppp command in your config. You should also
have a ppp multilink for both bris to come up. Also you may want to add the
dialer-load threshold 1 either command which wil lbring up botrh bris
immeidately. Also ad the dialer-idle timeout command. I usually use 30.
I take it your not using authentication? Otherwise you will need the ppp
authentiication pap or chap command. Then specify username and password on
the calling router...
Hope this helps..
Chris Martin
CCNP/CCDP/MCSE
----- Original Message -----
From: "Roger McNeace" <rmcneace@lucent.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, May 01, 2001 6:49 AM
Subject: Cannot get ISDN to work
> Can anyone tell me what I am doing wrong. I can not get the following ISDN
> lab configs to work. I also included output from show and debug commands.
> Thanks
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:31 GMT-3