From: David Goldsmith (dgoldsmi@xxxxxxxxx)
Date: Fri Apr 27 2001 - 12:57:17 GMT-3
Peter,
I don't believe that's true, I have tried this in the lab with OSPF and it does
change the behavior of the router. If I get time I will verify with ISIS. Ip
classless is to
have the router function classless or classful mode.
Thanks,
Dave G.
Peter Van Oene wrote:
> However, it has been verified that configuring IS-IS or OSPF on a router will
automatically place the router in classless mode regardless of the ip classles
s nob's setting
>
> *********** REPLY SEPARATOR ***********
>
> On 4/27/2001 at 2:57 PM Atif Awan wrote:
>
> >This command changes the router's lookup algorithm. No doubt OSPF is a
> >classless protocol but it only provides the router with the routes, it
> >does
> >not in any way affect the way a router determines how to forward packets (
> >that is using the classful or the classless algorithm ).
> >
> >>From: "radha rani" <radhaccie@hotmail.com>
> >>Reply-To: "radha rani" <radhaccie@hotmail.com>
> >>To: ccielab@groupstudy.com
> >>Subject: ip classless
> >>Date: Fri, 27 Apr 2001 10:00:06 -0400
> >>
> >>I have a question re: ip classless. My understanding is that if there is
> >>no
> >>specific route for a subnet in the routing table, this command allows the
> >>router to forward packets to unknown destinations using the default route.
> >>This being the case when the destination is a subnet of a network which is
> >>known to the router.
> >>
> >>My question is : since OSPF is a classless protocol, why do I need this
> >>command to have the router forward packets using the default route. I see
> >>this all the time where the router will not utilize the default route
> >until
> >>this command is added.
> >>
> >>I can unserstand needing it with IGRP/RIP but why with OSPF?
> >>
> >>Can someone expalin. Thanks so much.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:59 GMT-3