From: Carlos Chorao (cchorao@xxxxxxxxxx)
Date: Mon Apr 23 2001 - 22:49:54 GMT-3
Paul ,
I think the "update-source" command should refer to a Loopback ?
see http://www.cisco.com/warp/public/459/24.html
Carlos
-----Original Message-----
From: Paul Crist [mailto:pcrist@netsync.net]
Sent: Tuesday, April 24, 2001 1:10 PM
To: ccielab@groupstudy.com
Subject: Fat Kid BGP 320
I ran into a problem with this lab. It asks you to setup r1 and r4 with
internal bgp. r1, r2, r3 and r4 are also running eigrp. When I attempt to
configure bgp on r1 and r4 it does not work. I get an error saying
connection
refused and the local id is not the loopback, but another interface.
Here are the configs:
r1<------------>r2
| |
| |
| |
r3<----------->r4
r1
router bgp 200
bgp router-id 192.19.15.65
redistribute eigrp 200
neighbor 192.19.15.97 remote-as 200
neighbor 192.19.15.97 update-source Serial3
no auto-summary
r4
router bgp 200
no synchronization
bgp router-id 192.19.15.97
redistribute connected
redistribute eigrp 200
neighbor 192.19.13.1 remote-as 100
neighbor 192.19.15.65 remote-as 200
neighbor 192.19.15.65 update-source TokenRing0
no auto-summary
error from debug ip bgp on r4
03:22:24: BGP: 192.19.15.65 open active, local address 192.19.15.194
03:22:24: BGP: 192.19.15.65 open failed: Connection refused by remote host
Thanks,
Paul Crist
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:54 GMT-3