From: simplimarvelous (simplimarvelous@xxxxxxxxx)
Date: Thu Apr 19 2001 - 21:53:35 GMT-3
I have applied the following in hopes that i did somthing wrong, but the
ethernets can talk and no routes being put into my table for the other
interface.
do you see anything wrong?
r1
router isis gerald
net 49.0001.0000.0000.000a.00
!
int e0
ip add 192.2.2.1 255.255.255.0
ip router isis gerald
!
loop 2
ip add 13.3.3.3 255.255.255.0
ip router isis gerald
r2
router isis gerlad
net 49.0001.0000.0000.000b.00
!
int e0
ip add 192.2.2.2 255.255.255.0
ip router isis gerald
!
loop 2
ip add 14.4.4.4 255.255.255.0
ip router isis gerald
----- Original Message -----
From: "Jose Ferreira" <jvf@cisco.com>
To: "simplimarvelous" <simplimarvelous@yahoo.com>
Sent: Thursday, April 19, 2001 6:19 PM
Subject: Re: ISIS- any one know how to test isis network after configured
with basic config
I assume your're configuring ISIS for IP routing right? (CLNS is no longer
on the LAB).
Try PING like any other routing protocol. ISIS should basically do the same
as OSPF, although it is encapsulated directly over L2 and the configuration
is a little bit different than the other routing protocols.
Of course you will need IP addresses on the interfaces.
Regards,
Josi
At 15:51 19/04/01 -0700, you wrote:
>r1
>router isis
> net 22.4444.4444.4444.4444.22
>!
>int e0
> ip router isis
>
>
>
>r2
>router isis
> net 22.4444.4444.4444.4443.22
>!
>int e0
> ip router isis
>
>now what?
>how do i send traffic across?
>
>signed Clue-Less
>
>
>Gerald
>**Please read:http://www.groupstudy.com/list/posting.html
Josi Ferreira
Systems Engineer
Cisco Systems, NSP1 Portugal
Tel: +351 21 446 8728
GSM: +351 91 940 1830
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:52 GMT-3