From: louie kouncar (lkouncar@xxxxxx)
Date: Thu Apr 19 2001 - 20:41:26 GMT-3
You can't use frame relay on a token ring or Ethernet.
Louie J. Kouncar (CCIE)/Written
TCO3 Senior Data Center Engineer
UUNET
W-703-343-6645
C-703-304-2460
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Carl Phelan
Sent: Thursday, April 19, 2001 6:40 PM
To: ccielab@groupstudy.com
Subject: Frame Relay Switch with 2 Routers
Hi,
I am following the document from CCprep to create a frame relay switch from
two 2501s. When I come to enter the following command:
'frame-relay route 501 interface t0 105'
in interface mode on Serial 1, the router reports an error in the command
syntax with 't' or even the full word 'tunnel'. When I replace 't0' with a
?
the response is that it only expects the word 'serial'.
I have tried IOS ver 11.1, 11.2 and 12.0 with the same problem on different
routers - anybody have any ideas?
Thanks.
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:52 GMT-3