From: Misbahuddin Mohammed (Misba@xxxxxxxxxxxxxxxxxxxx)
Date: Mon Apr 16 2001 - 17:06:33 GMT-3
Try this ,it worked for me.
This is useful if your terminal emulator doesn't support the break key, or
if a bug prevents it from sending the correct signal (the hyperterminal
under Windows NT used to suffer from this behavior):
Connect to the router with the following terminal settings:
1200 baud rate
No parity
8 data bits
1 stop bit
No flow control
You will no longer be able to see any output on your screen. This is normal.
Power cycle (switch off and then on) the router and press the spacebar for
10-15 seconds. This generates a signal similar to the break sequence.
Disconnect your terminal and reconnect with a 9600 baud rate. You should now
be in ROM Monitor mode
Misba
-----Original Message-----
From: simplimarvelous [mailto:simplimarvelous@yahoo.com]
Sent: Monday, April 16, 2001 12:49 PM
To: ccielab@groupstudy.com
Subject: breaking sequence for hyperterminal
all,
if the traditional ctrl+break, or alt+B keys don't work is there another
method for sending a break ??? i heard somthing about changing baudrate and
entering a lot of key strokes , therfore sending invalid characters and the
router takes this a break signal.
has not worked for me ... any ideas?
gerald
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:47 GMT-3