From: Mas (tealp729@xxxxxxxx)
Date: Sun Apr 15 2001 - 22:24:44 GMT-3
Hi,
Try either changing the Cat's trcfr ring number to 0xa (hex 'A' or 10
decimal) OR changing the first parameter in R2/To0's source-bridge
statement to 16. Then change the Cat's trbrf bridge number to something
other than 0x1 so that you don't have two bridge 1's on the same ring...
Regards,
Mas Kato
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Nodir Nazarov
Sent: Sunday, April 15, 2001 12:37 PM
To: ccielab@groupstudy.com
Subject: SR/TLB on Cat5xxx
Hello,
I have a router (R2 - 2513) ethernet interface of which is connected to
Eth module of Cat5 and TR interface is connected to TR module of same
Cat5. R1 is connected to Cat5's Eth module and R3 - to TR module.
R1--Cat5--R2
R3/
I am having problems configuring SR/TLB on R2 between R1 and R3. Config
on R2:
!
source-bridge ring-group 100
source-bridge transparent 100 200 1 20
interface Ethernet0
bridge-group 20
bridge 20 protocol ieee
interface TokenRing0
source-bridge 10 1 100
!
Catalyst config:
set vlan 7 name BIGBRIDGE type trbrf mtu 4472 said 100007 state active
bridge 0x1 stp ibm
set vlan 77 name BIGRING type trcrf mtu 4472 said 100077 state active
parent 7 ring 0x10 mode srb aremaxhop 7 stemaxhop 7 backupcrf off
Is this supposed to work ? As I see Ring10 has 2 bridges - TRBRF and the
one on R2. Is it how it should be ?
Thanks for any hints !
Nodir
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:46 GMT-3